Home elevator installation in Leander

Georgetown Home Elevators works in Leander on houses still being framed and on homes that were never planned for one. We install enclosed elevators, through-floor lifts and glass elevators. First we need to know which floors you want to reach and who will ride.

Before anything is built, we go through the plans or walk the house with you. Together we decide what changes, what stays and what has to be settled before work starts.

Plan this project
Residential elevator cabin with oak finishes beside an interior staircase

Home elevator installation options

Shaftless home elevator installation

Through-floor lifts can suit some two-level homes, and there is no shaft to build. The floor opening still needs framing to carry the lift, and each landing needs room to step or roll off. Many models connect just two levels, so a house with a half landing or a third floor may need a different elevator even if the lift fits the corner. We look at the exact travel and stops of the model you like, plus its cab size and capacity, against the people who will use it.

Enclosed home elevator installation

A standard enclosed elevator runs in its own shaft with a cab chosen for your floors and riders. The drive changes how much space it takes. A hydraulic elevator needs a place for its power unit and parts and a way for a technician to reach them, and how much room that takes depends on the model, so we don’t assume every hydraulic needs the same room or pit. Traction and other drives can place their machinery differently. Your model’s drawings give us the pit, headroom, doors and service access before the framing is set.

Glass home elevator installation

A glass elevator turns the ride into part of the room. Some models are sold as a single package with the enclosure, which looks simple but still needs the right structural support, clearances and doorways. Behind the glass, the drive, capacity, wheelchair access and building work vary from model to model. We work from the maker’s full installation drawings to see how much floor each one takes on every level, and we plan the whole enclosure and its doors along with the glass.

Home elevator retrofit installation

To add an elevator to a house you already own, we need a clear route through every floor. Two closets stacked one above the other look ideal, but they can hide structure or utilities that block the way, so we check the full height before treating them as a shaft. A spot by the stairs or a new enclosure are the other usual choices, and each changes the framing, the utilities and the rooms you keep in its own way. We also look at the space outside the elevator door on every floor and how it meets the hall.

Home elevator installation for new construction

On a new Leander build, pick the elevator before the plans are final. Decide the stops, the cab size and where the doors open early, and keep your architect working from the latest elevator drawings. Pit depth, headroom and door details differ from model to model, so we take them from the drawings of the model you pick. If you want to add the elevator later, we size the space around a real model so the framing is ready when you are.

Check the address and the whole job

Leander sits in both Williamson and Travis counties, so we check the local building rules against your exact address and parcel. The elevator is only part of the job. The framing changes and the electrical work need review too, and we coordinate all three.

In an existing house, we compare how each possible spot changes the rooms on both floors. A door off an upstairs bedroom, the main living room and a lower entry each need different space to get in and out. On a new build, we settle that while the floor plan can still move. Either way, we give you the inside cab size, door width and landing space, so you can check them against who will ride and any wheelchair or walker.

Plan the job before anything is built

Map the passenger route

List every floor the elevator should reach and how the rider gets to each landing. If there’s a wheelchair or walker, we need its size, and whether someone rides along to help. Any plans or photos help, if you can take them safely. With those, we choose a layout with you that fits a real route through your house.

Who builds what

We lay out who designs and supplies each piece: the support, the floor openings or shaft, the doors, the wiring and the finishes around the elevator. In a lived-in house, we tell you which rooms and utilities the work will touch. In a new build, we lock in the space before the foundation and framing make it hard to change. That way you know what we do and what your builder does.

Inspection, first ride and upkeep

Before anyone rides it, the elevator gets its state inspection. Then we go over the controls, how to call for help from the cab and what it does in a power cut. We also explain how routine servicing works and who handles it locally. Hold on to the model, installation and maintenance papers along with your other house records, because a home elevator needs care for as long as it runs.

Confirm the Texas installation requirements

Before work starts, we confirm any local building, structural and electrical approvals for your address. At the state level, Texas requires a licensed contractor to install the elevator and an inspection to follow, single-family homes included.

We work in Liberty Hill too, where we first check city limits.

Frequently asked questions

Do Texas elevator rules apply to a private home?

Yes. A private home is not exempt, so we confirm the state and local requirements for your address before work begins.

Will a home elevator fit in a closet?

It can. Closets stacked floor over floor are a natural place to look, but the elevator also needs the right framing, a pit or enough headroom, door openings and space at each landing.

Are all home elevators wheelchair accessible?

No. Cab size, door width and weight limit vary by model, and some cabs are too small for a chair. We size the elevator to your chair and anyone riding with it.

What happens if the power goes out?

Each model has its own routine: lowering to a landing, or carrying on with backup power. When we hand it over, we show you yours, and the instructions stay with your house papers.

Request a free home elevator quote

Give us your Leander address, any plans or reports you have and a few lines about the job. We’ll come back with a free quote or our questions.

Call (737) 245-0222

Call (737) 245-0222